Remote Control Guide

Underbed

Lights On/Off

Head Up/Down

*Anti-Snore

Preset

Bed Height

Up/Down

**Bed-Height

Preset #1

Motion Activated Lighting Switch On(Up) / Off(Down)

Note: Press the Flat button to conrm selection.

Foot Up/Down

*Read Preset

**Bed-Height

Preset #2

Flat Position

Massage Cycle

Zero-G® Preset

REMOTE CONTROL OVERVIEW

*TO PROGRAM A NEW HEAD/FOOT ARTICULATION PRESET: Articulate the head

and foot to your desired position. Press and hold one of the preset buttons [Snore,

Read] for 7 seconds. The position is now saved.

**TO PROGRAM A NEW BED HEIGHT PRESET: Raise or lower the bed to your desired

bed height. Press and hold one of the preset buttons [In, Out] for 7 seconds. The

position is now saved.

NOTE: To restore the preset buttons back to their original factory settings, hold FLAT

and ZERO-G® simultaneously for at least 5 seconds. The original presets will be restored.

PAGE 1
REMOTE CONTROL OVERVIEW Motion Activated Lighting Switch On(Up) / Off(Down) Note: Press the Flat button to confirm selection. Underbed Lights On/Off Massage Cycle Zero-G® Preset Head Up/Down *Anti-Snore Preset **Bed-Height Preset #1 Foot Up/Down *Read Preset **Bed-Height Preset #2 Bed Height Up/Down Flat Position *TO PROGRAM A NEW HEAD/FOOT ARTICULATION PRESET: Articulate the head and foot to your desired position. Press and hold one of the preset buttons [Snore, Read] for 7 seconds.
PAGE 2
THE PUCK The Puck is more than a wireless device charger, it also functions as a voice activated remote control. Switch the toggle on the back of the Puck to select an invocation phrase, either “HELLO DAWN” or “HELLO BED”. Use this phrase to activate the microphone for 8 seconds, then utter one of the voice commands below to control the base. See the owner’s manual for additional commands and information.