User Manual

OPERATION INSTRUCTION
Note: The receiver(inside the motor)provides the function of multiplicative protection.
1.Lock position: The DC motor has a built-in safety feature against obstruction during
operation. If this occurs, the motor will discontinue operation within 3 seconds of
interruption. To reset, simply disable power supply to the fan motor and re-start.
2.Over 80W protection: When the receiver detects power consumption is greater the 80W,
the receiver power will immediately discontinue. To reset, simply disable power supply
to the fan motor and re-start.
3.Blade setup of motor is arrange according to loading condition; please only install
approved blades from a certified dealer or this may avoid the factory warranty.
●Products shall be subject to any changes without additional notices due
to DawnSun will keep innovation and optimization on the products.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference
This device must accept any interference received including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment
.
.
,(2)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and use in accordance with
the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4.Consult the dealer or an experienced radio/TV technician for help.
,
Caution: Changes or modifications not expressly approved by the party responsible for compliance