User manual

&&&&&&&&&&M4.2S&User&Manual&

Unpacking"and"Installing"the"M4.2S

Immediately upon receiving your M4.2S, please make a careful inspection for any shipping damage. If

damage is found or suspected, please notify the carrier at once and then contact your dealer.& & The

DaySequerra M4.2S is shipped in one carton, which contains: the M4.2S unit, an AC power cable, a

Torx

T-8 L-key and this User Manual.

We strongly encourage you to save the shipping carton and shipping materials supplied with

your M4.2S. They are specially designed to properly protect your M4.2S, and in the event that you

need to return it for service, only these OEM shipping materials can ensure its safe return to our

factory.

We provide a limited 3-year warranty on all of our products, but if you don’t register your unit, it’s hard

for us to contact you when software updates become available. So please take a few minutes to

complete the warranty registration form on our web site, www.daysequerra.com. Thank you!

Rack Mount Installation. The M4.2S chassis has four rack mounting holes in its chassis and has

been designed to fit in a 19” standard 1RU space. Plastic ‘finishing’ washers are recommended to

protect the painted finish around the mounting holes.

Power Connection. The AC power cable supplied with the M4.2S must be connected from the

M4.2S’s IEC320 power entry module to an AC mains outlet with a functional earth ground connection.

The M4.2S has been set at the factory to operate at 120VAC unless otherwise specified on the

shipping carton. The M4.2S export version is configured for 240VAC operation. Please connect your

M4.2S to an uninterruptible power supply (UPS) to protect against power surges and brownouts.

Antenna Input Connections. Separate 75ohm F-type connector is provided on the M4.2S rear panel

for dedicated AM and FM antennas

Audio Output Connections. Analog audio left and right outputs are on rear-panel XLR connectors

with pin 1 GND, pin 2 + and pin 3 -. The digital audio output is transformer-isolated in S/PDIF format on

a rear-panel XLR connector with pin 1 GND, pin 2 XFMR and pin 3 XFMR. The M4.2S digital audio

output is 5.1 surround capable.

Ethernet Connection - The M4.2S Ethernet Port offers the use of DaySequerra’s Webserver by

connecting the M4.2s to any networked computer with internet access. The use of crossover cables

can be used in areas where a network connection is not possible. More information on the Webserver

can be found at the end of this manual. The Ethernet port with the aid of the webserver will keep the

M4.2S up to date on all Firmware upgrades by checking, downloading and installing with the click of the

‘Check Firmware’ button on the webserver. (An internet connection must me available for ‘Firmware

Upgrade. to work. UPON RECEIVING THE UNIT IT IS ENCOURAGED TO ‘CHECK FIRMWARE’

FROM THE WEBSERVER TO BE SURE YOUR M4.2S IS USING THE MOST RECENT FIRMWARE

AVAILABLE.