User Manual

NOTICE The new polyurethane body mounts in your kit will be

a different size than the

original mounts that you are replacing. Even though they appear to be a different size, they

are the correct size for your truck and will position the cab at the original factory height. Also,

the kit contains mounts for all cab styles and not all pieces will be used on your truck.

Installation Instructions

1. Read the instructions completely before beginning installation. A floor jack and basic

hand tools are needed.

2. Disconnect the battery and remove the airbag fuse.

3. Remove the trim securing the carpet down at the doors so you can access the body

mount bolts. On Super Cab and Super Crew Cab models you must remove the rear

seat. Remove cab plugs to gain access to the cab mount bolts. See figure 1.

NOTICE On early model trucks the bolts go down from the top. On later model trucks (’08

and up), the bolts will come up from the bottom instead of down from the top.

4. All POSITONS - Remove the bolts from the passenger side body mounts and loosen

the driver’s side body mount bolts, but do not remove them. See figures 2 and 3.

5. POSITION 1 - On the front radiator support bolts, you will need to remove the upper nut

on the inside of the radiator support and then you can loosen the lower bolt. A 24”

extension with a universal swivel and an 18mm socket works well for this on most trucks.

You might need to have someone hold the mounts with large adjustable pliers while you

loosen the bolts. On some models, the front bumper must be removed to access the

bolts.

6. Using a floor jack, carefully place the jack on the passenger side floorboard support

mounts and lift high enough to remove the body mounts. Make sure the cab is securely

supported with jack stands before working under the truck, or removing any mounts.

7. ALL POSITIONS - Remove and replace the passenger side body mounts one at a

time. Take care not to mix up the pieces. The upper and lower mounts are clipped

together on the frame and you may have to use a pair of large screwdrivers to pry the

mounts off. Separate the lower pieces from the uppers carefully. You will be reusing the

original steel parts. See figure 4.