Owner manual

Thank you for choosing Daystar

Daystar recommends a certified technician install this system . In addition to these

instructions , professional knowledge of disassemble/reassembly procedures as well

as post instruction checks must be known. Attempts to install this system without

this knowledge and expertise may jeopardize the integrity and/or operating of the

vehicle.

Please read all the instructions before beginning the installation. Check the kit hard-

ware against the parts list. Be sure you have all the needed parts and understand

where they go. If anything is missing , do not proceed with the installation, Call

Daystar Products to obtain needed item

Product Use Information

As a general rule, the taller a vehicle is the easier it will roll. We strongly recom-

mend , because of rollover possibility, that Seat belts and shoulder harness be worn

at all times. Avoid situations where a side rollover may occur.

Braking performance and capabilities are decreased when significantly large/heaver

tires and wheels are used. Take this into consideration while driving, also , speed-

ometer recalibration is necessary when larger tires are installed.

Do not add, alter, or fabricate any factory or after-market parts which increase vehi-

cle height over the intended height of the Daystar Product purchased. Mixing com-

ponent brands, lifts, and/or combining body lift with suspension lift voids all war-

ranties. Daystar makes no claims regarding lifting devices and excludes any and all

implied claims. We will not be responsible for any products that are altered.

Notice to Dealer and Vehicle Owner

Any vehicle equipped with any Daystar Product must have the “Warning to driver”

decal installed on the sun visor or dash. The decal is to act a constant reminder for

whoever is operating the vehicle of its unique handling characteristics. INSTALL-

ING DEALER— Its is your responsibility to install the warning decal and forward

these instructions on too the vehicle owner for review and to be kept in the vehicle

for service life.

After installation occurs, a qualified alignment facility is required to align the vehi-

cle to factory specs.

Using your hand push down on the back of the panel so the 2 clips will

latch down.

10. With the panel installed you can use your favorite electronic devices.