User Manual

ManualsBrandsDaystar ManualsFor the carKT09104BK

www.DaystarWeb.com

Tech Support Contact Info

Tech@DaystarWeb.com

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

Avenue

Phoenix, AZ 85043

Instruction Sheet P10505-10

2008 Daystar Products International Inc.

1 of 4 pages

Toyota Tundra 2 1/2

Easy Front Install & Rear Add-a-Leaf

4wd & 2wd 6 lug only

1995.5-2006

KT09104

Summary of content (4 pages)

PAGE 1
www.DaystarWeb.com Tech Support Contact Info Tech@DaystarWeb.com Phone: 623.907.0081 Fax: 623.907.0088 841 South 71st Avenue Phoenix, AZ 85043 KT09104 Toyota Tundra 2 1/2 Easy Front Install & Rear Add-a-Leaf 4wd & 2wd 6 lug only 1995.5-2006 Instruction Sheet P10505-10 2008 Daystar Products International Inc.
PAGE 2
Installation Steps 1. Read all instructions and check bill of materials and tools before beginning. 2. Disconnect the negative battery cable. 3. Place the vehicle on a clean and level surface. Set the parking brake and place wheel chocks behind the rear wheels. Jack up the front of the vehicle by the frame with a floor jack and support vehicle at the frame rails with approved jack stands. NEVER WORK UNDER AN UNSUPPORTED VEHICLE. 4.
PAGE 3
Installation Steps 8. Remove the lower strut bolt and nut ( 19mm) . 9. Remove the strut from the vehicle. 10. Install the stud extenders and spacer on the top of the strut plate. 11. Reinstall the strut into the vehicle and tighten the upper strut nuts. You will have to push up on the upper a-arm to get the strut back in. 12. Reinstall the suspension working in reverse order. 13. Recheck all bolts after 500 miles. 14. Daystar Recommends that you have your wheel alignment checked.
PAGE 4
Installation Steps Rear 15. Lift the rear of vehicle and place jack stands on frame so that the rear tires almost touch the ground 16. Remove the rear tires and wheels. 17. Disconnect the rear shocks at the axle. 18. Support the rear axle with the floor jack and loosen all four U-bolts. Remove two U-bolts and clamp from one side. 19. Lower the axle away from the spring so that the drum is clear of the leaf Spring. Bend the spring clamps down and away from the spring.