User Manual

KT09107 & KT09108 Toyota 4-Runner 1996-2001
1½” & 2½” Rear Coil Spring Spacer Instructions
www.DaystarWeb.com
Tech Support Contact Info
[e-mail]
Phone. [phone]
Fax. [phone]
841 South 71
st
Avenue
Pho
enix, AZ 85043
1. Jack up rear end and place jack stands under frame allowing rear suspension to move up and down freely.
2. Disconnect lower shock mount bolts/nuts so that the rear axle droops and the coil springs become loose.
3. Disconnect the pan-hard bar at the drivers side if the axle.
4. Remove the coil spring and the coil spring isolator/bump-stop.
5. Install the isolator/bump-stop into the new coil spring spacer and then onto the frame. Install the coil spring
in between the coil spring spacer and the axle. (Note: you may have to pry the coil spring onto the axle
pad.)
6. Jack up the rear suspension so that the coil spring seats into the coil spring spacer and on the axle pad.
Reconnect the lower shocks mount bolts/nuts and reconnect the pan-hard bar.
7. Jack up the rear of the vehicle, remove the jack stands and lower the vehicle. Recheck all bolts/nuts for
tightness
Instruction Sheet P10503Rev00
 2000 Daystar Products International Inc.