Manual

ManualsBrandsDaystar ManualsCarKT09119-1

www.DaystarWeb.com

Tech Support Contact Info

Tech@DaystarWeb.com

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

Avenue

Phoenix, AZ 85043

Instruction Sheet P10494-13

2008 Daystar Products International Inc.

1 of 3 pages

Toyota Tacoma 2 1/2

Easy install front & rear shackle

4wd & 2wd 6 lug only

1995.5-2004

KT09102

Summary of content (4 pages)

PAGE 1
www.DaystarWeb.com Tech Support Contact Info Tech@DaystarWeb.com Phone: 623.907.0081 Fax: 623.907.0088 841 South 71st Avenue Phoenix, AZ 85043 KT09102 Toyota Tacoma 2 1/2 Easy install front & rear shackle 4wd & 2wd 6 lug only 1995.5-2004 Instruction Sheet P10494-13 2008 Daystar Products International Inc.
PAGE 2
Installation Steps 1. Read all instructions and check bill of materials and tools before beginning. 2. Disconnect the negative battery cable. 3. Place the vehicle on a clean and level surface. Set the parking brake and place wheel chocks behind the rear wheels. Jack up the front of the vehicle by the frame with a floor jack and support vehicle at the frame rails with approved jack stands. NEVER WORK UNDER AN UNSUPPORTED VEHICLE. 4.
PAGE 3
Installation Steps 8. Remove the lower strut bolt and nut ( 19mm) . 9. Remove the strut from the vehicle. 10. Install the stud extenders and spacer on the top of the strut plate. 11. Reinstall the strut into the vehicle and tighten the upper strut nuts. You will have to push up on the upper a-arm to get the strut back in. 12. Reinstall the suspension working in reverse order. 13. Recheck all bolts after 500 miles. 14. Daystar Recommends that you have your wheel alignment checked. TOOLS NEEDED 1. 2. 3. 4.
PAGE 4
Installation Steps CAUTION: BEFORE BEGINNING INSTALLATION. READ INSTRUCTIONS CAREFULLY AND COMPLETELY. 15. Park vehicle on a level work area and set emergency brake. Block front tires and lift the rear of the vehicle until the wheels clear the ground approximately 3”. Place jack stands under frame rail behind inner spring perch. Lower vehicle onto jack stands with axle supported by floor jack. 16. Carefully remove upper and lower spring shackle mounting hardware and left and right shackle plates.