Manual

Installation Steps
1. Read all instructions and check bill of materials and tools before beginning.
2. Disconnect the negative battery cable.
3. Place the vehicle on a clean and level surface. Set the parking brake and
place wheel chocks behind the rear wheels. Jack up the front of the vehicle
by the frame with a floor jack and support vehicle at the frame rails with ap-
proved jack stands. NEVER WORK UNDER AN UNSUPPORTED VE-
HICLE.
4. Disconnect the ABS and brake lines from the upper a-arm and spindle
( 10mm and 12mm bolts.
5. Disconnect the sway bar on both side at the spindle. ( 17mm bolt. )
6. Remove the upper strut nuts.( 14mm nuts ) You will need to reuse them later.
7. Remove upper ball joint nut ( 19mm nut ) and separate the ball joint from the
spindle by hitting the side of the spindle. DO NOT use a ball joint separator
tool it can damage the ball joint boot.