Owner's manual

ManualsBrandsDaystar ManualsFor the carKT09131-1

TOOLS NEEDED

•

14mm socket

•

19mm socket

•

22mm socket

•

24mm socket

•

5/8 wrench

•

14mm wrench

•

19mm wrench

•

22mm wrench

•

24mm wrench

•

Lug nut socket

•

4 ton floor jack

•

2 Jack stands

•

2 Wheel chocks

BILL OF MATERIALS

•

M03800 x 2 spacers

•

BU76093 x 1 hardware

♦

S11105 x 8 stud extenders

♦

P11153 x 1 thread lock

2007-12 Toyota Tundra 3” front lift kit

2WD & 4WD

Part KT09125

www.Daystarproducts.com

Tech Support Contact Info

Tech@DaystarWeb.com

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

Avenue

Instruction Sheet P11258

2007 Daystar Products International Inc.

Summary of content (4 pages)

PAGE 1
TOOLS NEEDED • • • • • • • • • • 14mm socket 19mm socket 22mm socket 24mm socket 5/8 wrench 14mm wrench 19mm wrench 22mm wrench 24mm wrench Lug nut socket • • • 4 ton floor jack 2 Jack stands 2 Wheel chocks 2007-12 Toyota Tundra 3” front lift kit 2WD & 4WD Part KT09125 BILL OF MATERIALS • • M03800 x 2 spacers BU76093 x 1 hardware ♦ S11105 x 8 stud extenders ♦ P11153 x 1 thread lock www.Daystarproducts.com Tech Support Contact Info Tech@DaystarWeb.com Phone: 623.907.0081 Fax: 623.907.
PAGE 2
Thank you for choosing Daystar Products Daystar recommends a certified technician install this system. In addition to these instructions, professional knowledge of disassemble/reassembly procedures as well as post instructions checks must be known. Attempts to install this system without this knowledge and expertise may jeopardize the integrity and/or operating of the vehicle. Please read all the instructions before beginning the installation. Check the kit hardware against the parts list.
PAGE 3
Installation steps 1. 2. 3. The tools needed for installation are on the back cover. A list of parts in the kit are under the tool listing. Make sure you have all of the proper tools and understand these directions before proceeding. Place the truck on a clean level surface and set the parking brake. Chock the rear wheels and using a floor jack raise the front of the truck and support the truck with approved jack stands under the frame rail behind the front wheels.
PAGE 4
7. Put thread lock on the 8 ( S11105) stud extenders and using a 5/8 wrench install them on the strut, then install the strut spacer( M03800) over the stud extenders. 8. Install the strut assembly with the spacer installed back into the truck and put the 4 upper strut nuts on to hold the strut from falling out. 12. Using a 24mm socket tighten the inner lower control arm bolts. 13. Reinstall the tires and tighten the lugs to 85 ft lbs. Jack up the truck and remove the jack stands.