User guide

Control arm assembling steps
4.
Install the control arm and rod in together.
5. With the control arm assembled, set the length of the arm by turn-
ing the rod end in or out .
Set the length of the arm to stock
length if not lifted. If lifted add a .250 to the length over 2.0”
of lift. This is only a starting length. You will need a wheel
alignment to get the arms set to the right length. From center
bolt hole center bolt hole.
6.
Block the front wheels and jack up the rear axle so you can remove
the rear wheel. With wheel removed place a jack stand under the rear
axle.
7.
With the Jeep setting on the jack stands, remove the upper control
arm bolts with a 18mm wrench and socket.
8.
Remove the upper control arm.
Installation steps