User Guide

GB-11
GB-12
Quick Starting Guide
Quick Starting Guide
1. Open the player by raising the
screen.
2. Remove the protective plastic
tab from the disc compartment.
Recommend to load it again to cover
the laser mechanism when not use
for long time.
3. Press OPEN/PUSH on the left to open the
compartment door.
4. Place a DVD disc
Align the center of the DVD disc with the center of the
disc guide. Press gently down on the DVD to snap the
disc into place, then close the door.
5. To switch on the unit, press the
ON button and hold on for about 2
seconds.
GETTING STARTED
To remove the pack, press
and hold the button on the side
of it and push the pack
backward untill it releases.
Release
button
6. Press ON again (less than 2 seconds) to start
playback.
In general, the DVD already inserted into the player
will start reading automatically when power is turned
on.
The DVD player will immediately start rendering
the DVD program.
When you want to stop, press the STOP button, it
will return to the power-on logo. To power off the
unit, slide the ON/OFF switch to the right.
The DVD player will automatically power off in three
minutes after entering screen saver mode. To reset
the unit, first press OFF and hold it for 3 seconds to
power off, and then power it on again.
TV TYPE
Your player can be set to one of the following TV
type:
• PAL is used in the Europe and
the default setting.
• NTSC is used by some other
countries, e.g. USA.
The selection is made by
repeatedly pressing the P/N
button.
We recommend you keep this
switch in the NTSC position
unless you are watching a PAL
disc.
PAL/NTSC
JDP-830(IE05082).qxd 2005.4.1 4:39 PM 页面11 (1,1)