User's Manual

4. The red light on the cadence sensor will ﬂash identifying that the cadence sensor

is good and has entered pairing mode.

5. The syncing process is complete when the window on the computer displays a

random ID number (e.g. ID123).

6. The computer will then automatically reboot.

Wait for 5 seconds.

You must wait for 5 seconds to allow the computer to reset the ID properly.

7. Test for response by turning the computer on then waving a magnet across the cadence sensor. By doing

this you are simulating the same motion as when the ﬂywheel rotates and the magnet passes by the

cadence sensor. If you see RPM displayed, then the cadence sensor and computer were synced

successfully. Proceed with the installation and mounting to the bike.

NOTE: Remember to keep the computer and cadence sensor as a set at all times.

Syncing Process - cont’d