User's Manual

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s authority to
operate this equipment. (Example-use only shielded interface cables when
connecting to computer or peripheral devices).
Radiation Exposure Statement
This equipment complies with F CC radiation exposure limits set forth for an
uncontrolled environment and it also complies with Part 15 of FCC RF Rules. Operation
is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user
authority to operate the equipment.
Canada Statement
This Device complies with RSS-210 of the IC Rules; Operation is subject to the following
two conditions:
(1) This device may not cause interference and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS
102 and users can obtain Canadian information on RF exposure and compliance from
the Canadian Representative as seen below:
Dynastream Innovations Inc.
228 River Avenue
Cochrane, Alberta, Canada
T4C 2C1
Phone: [phone]
Fax: [phone]
E-Mail: [e-mail]
Legal
Canada
FCC ID: O4GIPDWA
IC: 7666A - IPDWA