Installation Instructions

FCC/ISED Compliance Information
Model E41230 Model E41227 Central
FCC ID O4GAR FCC ID O4GRE FCC ID tbd
IC 7666A-AR IC 7666A-RE IC tbd
1. FCC Statement
ENG | This device complies with Part 15 of the FCC
Rules.
Caution: If any changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interfe-
rence, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
The grantee is not responsible for any changes
or modifications not expressly approved by the
party responsible for compliance. Such modifica-
tions could void the user’s authority to operate the
equipment.
The RF Exposure Compliance distance is 5 mm.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential instal-
lation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communica-
tions. However, there is no guarantee that interfe-
rence will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
› Reorient or relocate the receiving antenna.
› Increase the separation between the equipment
and receiver.
› Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
› Consult the dealer or an experienced radio/TV
technician for help.
2. ISED Statement
ENG | This device complies with Innovation, Science
and Economic Development Canada licence‐exempt
RSS standard(s). Operation is subject to the following
two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause
undesired operation of the device.
CAN ICES-3(B)/NMB-3(B)
The device meets the exemption from the routine
evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure, users can
obtain Canadian information on RF exposure and
compliance.
This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
This equipment should be installed and operated
with a minimum distance of 5 millimeters between
the radiator and your body.
FR | Le présent appareil est conforme aux CNR
Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de
licence. L‘exploitation est autorisée aux deux condi-
tions suivantes:
(1) il ne doit pas produire de brouillage et
(2) l’ utilisateur du dispositif doit étre prêt à
accepter tout brouillage radioélectrique reçu,
même si ce brouillage est susceptible de
compromettre le fomctionnement du dispositif.
CAN ICES-3(B)/NMB-3(B)
Le dispositif rencontre l‘exemption des limites
courantes d‘évaluation dans la section 2.5 de RSS
102 et la conformité à l‘exposition de RSS-102 rf,
utilisateurs peut obtenir l‘information canadienne
sur l‘exposition et la conformité de rf.
Cet émetteur ne doit pas être Co-placé ou ne fonc-
tionnant en même temps qu‘aucune autre antenne
ou émetteur. Cet équipement devrait être installé
et actionné avec une distance minimum de 20
millimètres entre le radiateur et votre corps.