Operating instructions

Dayton Operating Instructions and Parts Manual
2
Dayton Propane
Construction Heater
®
4E236C
General Safety Information
IMPORTANT: Make certain you read
and understand all warnings. Keep
these instructions for reference. They
are your guide to safe and proper
operation of this heater.
Safety information appears throughout
these instructions. Pay close attention to
them. Below are definitions for the safety
information listed throughout this manual.
IMPORTANT: Not every possible circum-
stance that might involve a hazard can be
anticipated. The warnings in this manual
and on tags or decals affixed to the unit
are therefore not all-inclusive. If a
procedure, work method, or operating
technique not specifically recommended
by Dayton is used, you must make sure it
is safe for you and others. You should
also ensure that equipment will not be
damaged or made unsafe by the operat-
ing or maintenance method you choose.
Under this heading,
installation, operat-
ing and maintenance procedures or
practices will be found that, if not
carefully followed, WILL result in IMME-
DIATE serious personal injury or death.
Under this heading,
installation, operat-
ing, and maintenance procedures or
practices will be found that, if not carefully
followed, MAY result in minor personal
injury, product, or property damage.
Under this head-
ing, installation,
operating, and maintenance proce-
dures or practices will be found that, if
not carefully followed, COULD result in
severe personal injury or death.
Specifications
ELECTRICAL SPECIFICATIONS
Electrical Input ............................................... 120V/60Hz
Amperage........................................................ 4.2
Motor ............................................................... 1/5 HP @ 1725 RPM
GENERAL SPECIFICATIONS
Output Rating BTU/Hr ..................................... 225,000 to 375,000
Fuel .................................................................. Propane Vapor Only
Minimum Fuel Consumption......................... 2.5 Gal/Hr 10.4 Lbs/Hr
Maximum Fuel Consumption ........................ 4.0 Gal/Hr 7.4 Lbs/Hr
Ignition ............................................................ Direct Spark
Regulator Outlet Pressure ............................. 7-20 psiG
Hot Air Output Approx. (CFM) ...................... 1500
Minimum Supply Pressure to Regulator...... 25 psiG (for purposes of input adjustment)
Maximum Supply Pressure to Regulator ..... Tank Pressure
Size L x W x H (Inches) ................................... 34" x 13" x 19.5"
Weight (pounds) ............................................. 42 (Heater) 49 (Shipping)
Temperature Control ...................................... Built-in Thermostat
Product Identification
Figure 2 – Product Identification
Hot Air Outlet
(Front)
Handle
Power
Cord
Outer Shell
Fan Guard
On/Off
Switch
Inlet Connector
Hose/Regulator
Assembly
REAR VIEW
Thermostat Knob