User Manual

24
OPERA10 OPERA12 OPERA 15
COD. 420120247 REV. 1.1
INPUT, OUTPUT AND CONTROL SECTION
3. "Main" GENERAL SETUP SECTION
It includes the 8-position "DSP Preset" rotary switch, the
"Limiter" and "Signal / ON" LED indicators and the "ground
lift" switch.
5. "Output" SECTION
Equipped with connector for balanced cable (XLR), it also includes the
"Out Routing Selector", required to differentiate the output inputs in
case of connection to a second speaker.
4. DSP PRESET - TABLE
The selectable presets are shown in this table as a reminder.
S1 - Club, suitable for a medium-small indoor environment
S2 - Vocal, optimises for vocal playback and performance
S3 - Bass reduction, with attenuation of low frequencies, for use in reverberant environments
S4 - Playback, optimised for music playback (such as MP3 reader)
S5 - Bass boost, suitable to emphasise low frequencies
Recommended presets for monitor use (wedge):
W1 - Wedge Vocal, to be used with monitor (wedge) position and vocal performance
W2 - Wedge Playback, to be used in monitor (wedge) position and playback of a music programme
Preset that excludes any equalization:
FLAT - to be set if no equalization is required
2. "CH2" INPUT SECTION
Provided with Combo connector to connect cables with
XLR and TRS (balanced and unbalanced) connectors,
includes channel level adjustment and a switch to adjust
input impedance (“Line” or “Instr”). “Instr” refers to a high
impedance such as that of a guitar or bass.
1. "CH1" INPUT SECTION
Equipped with a Combo connector to connect cables with
both XLR and TRS connectors (balanced and unbalanced), it
includes the regulation of the channel level and a switch to
adapt the impedance to line level ("Line"), or to microphone
level ("Mic").
English