User Manual

32
OPERA10 OPERA12 OPERA 15
COD. 420120247 REV. 1.1
5. TROUBLESHOOTING
1. Check that power supply is present upstream of the installation.
2. Ensure that the power supply cable with VDE connector is properly plugged in.
1. Check that the input connections of the audio signal (CH1 and/or CH2) are carried out correctly.
2. Check the cables for damage.
3. Ensure that the mixer or audio source is on and an output signal is present.
4. Check that the input levels (CH1 and/or CH2) are appropriate.
1. Adjust the rst source volume, then set the input (CH1 and/or CH2) gain to an adequate level. Check the
cables for damage and replace them as required (a damaged cable may lead to signal loss or alteration).
2. Check that the input selection settings (CH1 --> Mic/Line, CH2 --> Line/Instr) are correct with respect to
the source
3. Check that the "DSP preset" settings are suitable for the use selected.
The speaker will not turn on:
The speaker turns on but produces no sound:
Speaker sound is distorted or not sufcient:
1. Disconnect all connected devices and turn power supply off.
2. Check that the Ground Lift switch is correctly set.
3. Check the connection cables for damage.
4. Connect cables again and turn speaker on.
A background hum can be heard:
English