User Manual
www.dbtechnologies.cominfo@dbtechnologies‐aeb.com
SYA10Rev1.1cod.420120308Q
Technical Data
Speaker Type: 2-way active speaker
Acoustical data
Max SPL (1 m): 125 dB
Frequency response (-10 dB): 55 -18000 Hz
Frequency response (-6 dB): 58 -17000 Hz
HF compression driver: 1 " Exit
HF voice coil: 1”
LF: 10”
LF Voice Coil: 2”
Horizontal dispersion: 90°
Vertical dispersion: 60°
Amplifier
Amp: Custom made, Class-D + A/B– Active Fan cooling
Peak Power: 400 W
Operating voltage (
factory set
):
220-240V~ (50-60Hz) or
110-120V~ (50-60 Hz)
Processor
Controller: 28/56 bit
AD/DA Conversion: 24 bit, 48 kHz
Advanced DSP functions: FIR
Limiter: Peak, RMS, Thermal
Controls: Line/mic, Channel Volume, Link/Mix, Presets
Input / Output
Mains connections: VDE
Signal Inputs: 3 channels (Combo, XLR+trs, Bluetooth )
Signal Out: (Balanced) 1x XLR OUT (LINK)
Mechanics
Housing: Polypropylene
Handles: 2 (on sides)
Width: 310 mm (12.2 in)
Height: 530 mm (20.9 in)
Depth: 299 mm (11.8 in)
Weight: 11.3 kg (24.9 lbs)
EMI CLASSIFICATION
According to the standards EN 55032 and EN 55035 this equipment is designed and suitable to operate in class B electromagnetic environments
.
FCC ID: 2ADDV-TLSYA10
FCC CLASS B STATEMENT ACCORDING TO TITLE 47, PART 15, SUBPART B, §15.105
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth® SIG, Inc. and any use of such marks by AEB
Industriale SRL is under license. Other Trademarks and trade names are those of their respective owner.
RED CERTIFICATION
Hereby, AEB Industriale declares that SYA loudspeaker is in compliance with Directive 2015/53/EU, in reference to the following
harmonized standards:
Health & Safety EN 62479 / EN 62368-1+A11
EMC EN 301 489-1 V2.2.0, EN 301 489-9 V2.1.1, EN 55032, EN 55035
Spectrum EN 300 328 V2.1.1
SIMPLIFIED EU DECLARATION OF CONFORMITY
The full text of the EU declaration of conformity is available at the following internet address:
http://www.dbtechnologies.com/en/downloads
Features, specification and appearance of products are subject to change without notice.dBTechnologies reserves the right to make changes or
improvements in design or manufacturing without assuming any obligation to change or improve products previously manufactured.
Scan with your QR Reader App to download the
complete User Manual
Download the complete user manual from the site:
www.dbtechnologies.com/en/downloads.aspx