User's Manual
Table Of Contents
- Overview
- Installation
- User Interface & Connectors
- Getting Started
- Configuring The VENU360
- Operating The VENU360
- Manually Optimizing A System Using The VENU360
- Processing Modules & Parameters
- Inputs Module
- Router Module
- Mixer Module
- Advanced Feedback Suppression (AFS) Module
- Automatic Gain Control (AGC) Module
- Delay (DLY) Modules
- Compressor (CMP) Module
- Graphic EQ (GEQ) Module
- Noise Gate (GAT) Module
- Parametric EQ (PEQ) Modules
- AutoEQ (AEQ) Module
- Subharmonic Synth (SUB) Module
- Crossover Module
- Limiter (LIM) Module
- RTA
- Utility Menu
- Power-Up Functions
- Application Guide
- Application 1: Full Range Mains
- Application 2: Full Range Mains + Subs
- Application 3: Bi-Amplified Mains + Aux-Fed Subs
- Application 4: LCR Full Range Powered Mains + Subs
- Application 5: Full Range Stage Monitors
- Application 6: Bi-Amplified Stage Monitors
- Application 7: Using The AES Digital Inputs
- Application 8: BLU Link Application (VENU360-B)
- Application 9: Dante Application (VENU360-D)
- Preset List
- Using The VENU360 Control Application
- Networking
- Technical Information
- Additional Resources
98
Soft Reset
The Soft Reset function resets all Utility settings in the VENU360 back to their factory default state without resetting user
presets.
WARNING! Performing the Soft Reset procedure will reset all analog input and output clip levels, clock source,
and XLR input format settings in the Utility menu back to their factory default state. These settings are global but are
also important for the correct operation of your presets. It is recommended that you take note of all these settings before
performing the Soft Reset procedure. This allows you to easily set them back after the Soft Reset has been performed.
To perform a Soft Reset:
1� Power down the VENU360.
2� Press and hold the UTILITY button then apply power to the VENU360. Keep the button help until the “SOFT RESET
Release UTILITY button” message appears in the LCD display then release the button.
3� Press the WIZARD button to perform the Soft Reset procedure. Pressing the UTILITY button will cancel the operation.
Factory Reset
The Factory Reset function resets all user presets and Utility settings in the VENU360 back to their factory default state.
WARNING! Performing the Factory Reset procedure will permanently reset all user presets and set all VENU360
settings back to their factory default state. This operation is irreversible.
To perform a Factory Reset:
1� Power down the VENU360.
2� Press and hold the STORE button then apply power to the VENU360. Keep the button held until the “FACTORY
RESET Release STORE button” message appears in the LCD display then release the button.
3� Press the WIZARD button to perform the Factory Reset procedure. Pressing the STORE button will cancel the
operation.