User's Manual
Table Of Contents
- Overview
- Installation
- User Interface & Connectors
- Getting Started
- Configuring The VENU360
- Operating The VENU360
- Manually Optimizing A System Using The VENU360
- Processing Modules & Parameters
- Inputs Module
- Router Module
- Mixer Module
- Advanced Feedback Suppression (AFS) Module
- Automatic Gain Control (AGC) Module
- Delay (DLY) Modules
- Compressor (CMP) Module
- Graphic EQ (GEQ) Module
- Noise Gate (GAT) Module
- Parametric EQ (PEQ) Modules
- AutoEQ (AEQ) Module
- Subharmonic Synth (SUB) Module
- Crossover Module
- Limiter (LIM) Module
- RTA
- Utility Menu
- Power-Up Functions
- Application Guide
- Application 1: Full Range Mains
- Application 2: Full Range Mains + Subs
- Application 3: Bi-Amplified Mains + Aux-Fed Subs
- Application 4: LCR Full Range Powered Mains + Subs
- Application 5: Full Range Stage Monitors
- Application 6: Bi-Amplified Stage Monitors
- Application 7: Using The AES Digital Inputs
- Application 8: BLU Link Application (VENU360-B)
- Application 9: Dante Application (VENU360-D)
- Preset List
- Using The VENU360 Control Application
- Networking
- Technical Information
- Additional Resources
117
Technical Information
Firmware Updates
The USB or Ethernet connector on the back panel of the VENU360 can be used to perform firmware updates. Connect the
USB port to a compatible computer for performing firmware updates using the VENU360 Firmware Update Utility application.
As firmware updates becomes available, the Firmware Update Utility application will be available on the VENU360 product
page at dbxpro.com.
If using the DriveRack VENU360 control app, you can update the VENU360 via the Ethernet port straight from the
application, regardless of the device you’re using for control (i.e., iOS
®
, Android
™
, Mac
®
, or Windows
®
device). Follow the
included instructions provided with each application to perform the update procedure.