User's Manual
Table Of Contents
- Overview
- Installation
- User Interface & Connectors
- Getting Started
- Configuring The VENU360
- Operating The VENU360
- Manually Optimizing A System Using The VENU360
- Processing Modules & Parameters
- Inputs Module
- Router Module
- Mixer Module
- Advanced Feedback Suppression (AFS) Module
- Automatic Gain Control (AGC) Module
- Delay (DLY) Modules
- Compressor (CMP) Module
- Graphic EQ (GEQ) Module
- Noise Gate (GAT) Module
- Parametric EQ (PEQ) Modules
- AutoEQ (AEQ) Module
- Subharmonic Synth (SUB) Module
- Crossover Module
- Limiter (LIM) Module
- RTA
- Utility Menu
- Power-Up Functions
- Application Guide
- Application 1: Full Range Mains
- Application 2: Full Range Mains + Subs
- Application 3: Bi-Amplified Mains + Aux-Fed Subs
- Application 4: LCR Full Range Powered Mains + Subs
- Application 5: Full Range Stage Monitors
- Application 6: Bi-Amplified Stage Monitors
- Application 7: Using The AES Digital Inputs
- Application 8: BLU Link Application (VENU360-B)
- Application 9: Dante Application (VENU360-D)
- Preset List
- Using The VENU360 Control Application
- Networking
- Technical Information
- Additional Resources
26
Configuring BLU Link / Dante Inputs
When using the standard VENU360 model, input configuration is fixed with the following assignments: IN1: Analog1, IN2:
Analog2, IN3: Analog3, IN4: AES1, IN5: AES2, IN6: AES3, and IN7: AES4. In the VENU360-B and VENU360-D models,
inputs are configuable, allowing for the selection of the additional BLU link or Dante input channels. A combination of the
analog, AES, and BLU link/Dante channels can be selected. The selected 7 inputs can then be mixed or routed to any
available Router or Mixer module in the preset’s signal chain.
IMPORTANT NOTE: When using the VENU360-B model, BLU link channel assignments must be made in the
Utility > BLU link submenu or by running the BLU link Setup Wizard. These are the actual BLU link channels assigned to
the VENU360-B and are configured separate of presets. This allows VENU360-B BLU link channel assignements to be
edited at any time without breaking BLU link routing in all the presets. See ‘BLU LINK’ on page 92 for information on
manually editing BLU link channel assignment settings. See ‘Using The Wizards (Wizard Mode)’ on page 17 for
information on the BLU link Setup Wizard.
When using the VENU360-D model, Dante input channel assignments to the VENU360-D are made using Audinate’s
Dante Controller software.
To configure BLU link or Dante input channels:
1. Press the CONFIG button.
2. If it’s not already selected, select
the INPUTS module by turning the
SELECT wheel.
3. Press the SELECT wheel to enter
the Input Configuration menu.
4. Select the input you wish to edit
by turning then pressing the
SELECT wheel.
5. Select the desired option by
turning then pressing the SELECT
wheel.