User's Manual
Table Of Contents
- Overview
- Installation
- User Interface & Connectors
- Getting Started
- Configuring The VENU360
- Operating The VENU360
- Manually Optimizing A System Using The VENU360
- Processing Modules & Parameters
- Inputs Module
- Router Module
- Mixer Module
- Advanced Feedback Suppression (AFS) Module
- Automatic Gain Control (AGC) Module
- Delay (DLY) Modules
- Compressor (CMP) Module
- Graphic EQ (GEQ) Module
- Noise Gate (GAT) Module
- Parametric EQ (PEQ) Modules
- AutoEQ (AEQ) Module
- Subharmonic Synth (SUB) Module
- Crossover Module
- Limiter (LIM) Module
- RTA
- Utility Menu
- Power-Up Functions
- Application Guide
- Application 1: Full Range Mains
- Application 2: Full Range Mains + Subs
- Application 3: Bi-Amplified Mains + Aux-Fed Subs
- Application 4: LCR Full Range Powered Mains + Subs
- Application 5: Full Range Stage Monitors
- Application 6: Bi-Amplified Stage Monitors
- Application 7: Using The AES Digital Inputs
- Application 8: BLU Link Application (VENU360-B)
- Application 9: Dante Application (VENU360-D)
- Preset List
- Using The VENU360 Control Application
- Networking
- Technical Information
- Additional Resources
44
Copying/Pasting Processing Module Settings
In Edit mode, the COPY/PASTE buttons allow you to copy all parameters of a module and paste them to another like
processing module. A like processing module is one that is of the same processing type and contains the same parameters as
the processing module that was copied.
To copy/paste settings from one processing module to another:
1. Press the EDIT button.
2. Select the module you wish to
copy using the SELECT wheel and
UP/DOWN buttons.
3. Press the COPY button.
4. Select the like module you wish
to paste the settings to using
the SELECT wheel and UP/DOWN
buttons.
5. Press the PASTE button. Repeat
steps 2-5 to copy/paste additional
settings.
6. When done editing, press the
BACK button repeatedly to return
to the Home screen.
TIP: Processing module settings can also be copied and pasted between presets.