User's Manual

48
Deleting Presets
User presets can be deleted. Deleting a user preset creates an empty preset. When an empty preset is loaded, no signal will
pass through the VENU360. A new configuration can be created in an empty preset by running the System Setup Wizard or
pressing the CONFIG button.
To delete a preset:
1. Recall any preset that is not empty
then press the STORE button. See
TIP below table.
2. The current name of the preset
will be shown in the LCD display.
Press and hold the STORE button
for ~2 seconds.
3. Use the SELECT wheel and/or UP/
DOWN buttons to select the preset
you wish to delete.
4. Press the SELECT wheel to delete
the selected preset.
5. A confirmation screen will appear.
Select the “YES” option using
the SELECT wheel to confirm and
delete the preset.
WARNING! The preset residing in
the selected memory location will
be permanently deleted.
Selecting the “NO” option will
abort the procedure and return to
the last screen.
6. Repeat steps 3-5 to delete any
additional presets.
TIP: Pressing and holding the STORE button for ~2 seconds will take you straight to step 3.
00