User's Manual
Table Of Contents
- Overview
- Installation
- User Interface & Connectors
- Getting Started
- Configuring The VENU360
- Operating The VENU360
- Manually Optimizing A System Using The VENU360
- Processing Modules & Parameters
- Inputs Module
- Router Module
- Mixer Module
- Advanced Feedback Suppression (AFS) Module
- Automatic Gain Control (AGC) Module
- Delay (DLY) Modules
- Compressor (CMP) Module
- Graphic EQ (GEQ) Module
- Noise Gate (GAT) Module
- Parametric EQ (PEQ) Modules
- AutoEQ (AEQ) Module
- Subharmonic Synth (SUB) Module
- Crossover Module
- Limiter (LIM) Module
- RTA
- Utility Menu
- Power-Up Functions
- Application Guide
- Application 1: Full Range Mains
- Application 2: Full Range Mains + Subs
- Application 3: Bi-Amplified Mains + Aux-Fed Subs
- Application 4: LCR Full Range Powered Mains + Subs
- Application 5: Full Range Stage Monitors
- Application 6: Bi-Amplified Stage Monitors
- Application 7: Using The AES Digital Inputs
- Application 8: BLU Link Application (VENU360-B)
- Application 9: Dante Application (VENU360-D)
- Preset List
- Using The VENU360 Control Application
- Networking
- Technical Information
- Additional Resources
57
suppression.
NOTE: When ringing out the system in Fixed mode, any sound detected by AFS will trigger filters to be set. Therefore,
make sure the microphones are active, but there is no signal present at the mics when AFS is active in Fixed mode.
7. Add Finishing Touches
The system is now ready for use. Additional processing can now be applied to add the finishing touches. For example,
subharmonic synthesis can be applied to enhance the system’s bass response and compression can be applied to add a touch
of mixbus-style compression. For tips on setting these processing module settings, see ‘Compressor (CMP) Module’ on
page 71 and ‘Subharmonic Synth (SUB) Module’ on page 82.