Instruction Manual

Press Select to Load

> New Preset

Load New Preset

Press the <Data> wheel to load the new preset. The display will look like this:

Connect mic to RTA

input. Press RTA

input button.

Auto Level

The display is prompting you to connect an RTA-specific microphone to the front-panel

RTA XLR input, and press the <RTA Input> button. It is recommended that you use the

included dbx M2 RTA microphone, placed somewhere close to the middle of where your

audience will be. (If you wish to manually balance the individual speaker levels by ear,

you can skip the Auto Level portion of this wizard, by pressing the <Preset> button.)

Once you’ve connected the RTA microphone and pressed the <RTA Input> button, the

display will look like this:

Auto Level

You will now proceed to “Pink” the room by adjusting the Pink level. The range of

bar graph is -Inf dB to +20dB. Be certain to raise the pink noise level to the level of

loudness intended during the performance. Once the Pink level has been adjusted to the

desired volume, press the <Next Pg> button and the Auto Level sequence will begin. The

DriveRack PX will adjust balance levels for your main speakers (and your subs, if you have

them). Note that you may be prompted to readjust the your speaker knob settings. When

the Auto Level sequence is finished, the display will look like this:

Auto Level Complete

Release RTA INPUT

button to exit.

After you press the <RTA Input> button to release it, the display will look something like

this:

EON10g2wSub Loaded

and levels balanced.

<NEXT PG>-Auto EQ

<PRESET)-Exit Wizard

Press the <Next PG> button to start the Auto-EQ wizard.

•

DriveRack

Section 2

Getting Started