Instruction Manual

SETUP
AFS
RECALL
SUBHARMONIC
COMP/LIMITER
UTILITY
PRESET
NEXT PG
STORE
EQ
WIZARD
UTILITY
PREV PG
WIZARD
STORE/UTILITY - Press and release to enter the Store menu, which allows
the user to store the current state to a user preset. Press and hold to
adjust LCD contrast, Auto-EQ plot selection (RTA or GEQ), and Sales Banner
on/off.
SETUP
AFS
RECALL
SUBHARMONIC
COMP/LIMITER
UTILITY
PRESET
NEXT PG
STORE
EQ
WIZARD
UTILITY
PREV PG
WIZARD
AFS - Press and release to enter the Feedback processing editor. Press and
hold to enter the first page of the AFS Wizard.
3.3 Navigating the High-pass and Bandpass Filter (SETUP) Section
Freq - 20kHz - Out
Type -BW6-24,LR12,24
Gain- Inf to 20dB
SETUP
To edit the parameters of the high-pass and bandpass filter used in a selected preset, simply use the following procedure.
From preset mode, press the SETUP button. Once you have reached the high-pass and bandpass filter module, navigate through the
pages of the selected high-pass and bandpass filter module by pressing the "Next Page" or "Prev Page"
buttons successively until arriving at the desired Page.
Freq - 20Hz - Out
Type- BW6-24,LR12,24
Freq - 20kHz - Out
Type- BW6-24,LR12,24
Gain- Inf to 20dB
Type (BS,BW,L-R)
Frequency
Slope
SSub >
Type (BS,BW,L-R)
Frequency
Slope
<SSub
Successive presses of the Data wheel will select
effect parameters within the currently selected page.
SETUP
high-pass and bandpass filter
Sub Outputs Sub Outputs
Main Outputs
High-pass Low-pass
High-pass
3.4 Navigating the Subharmonic Section
The NEXT and PREV
buttons scroll through
the pages of selected module.
<PREV PG NEXT PG>
Navigating the Subharmonic Synthesizer Section
Subharmonic - -On/Off
Subharmonics % 0-100
24-36Hz Level - 24-36Hz
36-56Hz Level - 36-56Hz
SUBHARMONIC
SUBHARMONIC
From preset mode, press the SUBHARMONIC button. Pressing the Data Wheel will select the parameter to be edited.
Successive presses of the Data wheel will select
parameters within the currently selected page.
DriveRack
®
PX
Section 3
Editing Functions
®
16