User guide

P5040 DS Hardware Getting Started, Rev. 1.5
Freescale Semiconductor 23
Switch Default Settings
SW9 Configuration
SW9.1 – SW9.2: PIXISOPT[0:1]
(ngPIXIS Option)
Controls OCM/DCM ngPIXIS options.
• PIXISOPT[0] = ‘0’ - Enabled debugger
• PIXISOPT[0] = ‘1’ - Disabled debugger [Default]
• PIXISOPT[1] = unused; ‘1’ - [Default]
SW9.3: IPLWP
(IPL Write Protect)
Defines EEPROM FPGA ExConfiguration Data WP.
• ‘0’ - No EEPROM WP
• ’1’ - EEPROM WP [Default]
SW9.4: CFGWP
(Configuration Write Protect)
Defines EEPROM FPGA Configuration Data WP.
• ‘0’ - No EEPROM WP [Default]
• ’1’ - EEPROM WP
SW9.5: ATX-PS
(ATX Power Supply)
Defines if system automatically Powers-ON after ATX power supply is set to ON.
• ‘0’ - ATX-PS is turned on but the board remains OFF; then press the power
switch. [Default]
• ’1’ - Board powers automatically after ATX-PS is turned ON.
SW9.6: RESERVED
SW9.7: CFGOPT[0] - DCM SHELL
• ‘0’ - DCM works in background [Default]
• ‘1’ - DCM interacts over COM1 Port
SW9.8: CFGOPT[1] - DCM DIS
• ‘0’ - DCM inhibited (GMSA forced into RESET) [Default]
• ‘1’ - DCM operational (GMSA runs)
8 7 6 5 4 3 2 1
CFGOPT1 CFGOPT0 RESERVED ATX-PS CFGWP IPLWP PIXISOPT1
ON ’1’
PIXISOPT0