Installation Guide

BEFORE YOU BEGIN

1) Shut off water supply.

2) Carefully inspect waste and supply tubing for signs of damage.

3) Replace waste or supply tubing if n

ecessary

B) HANDLE VALVE INSTALLATION

1) Place lower plastic washer and lock nut over valve body.

2) Insert valve body from under the sink.

3) Place upper rubber washers and escutcheon on valve spindle.

4) Adjust position of valve body. Secure valve body with lock nut and escutcheon.

5) Place handle onto spindle.

6) Tighten handle

with screw.

TOOLS AND MATERIALS

Basin Wrench

Adjustable wrench

Teflon Tape

Pipe Wrench

Screwdriver

Flexible Water

Supply Line

HANDLE

ESCUTCHEON

RUBBER WASHER

PLASTIC WASHER

LOCK NUT

VALVE BODY

A) SPOUT INSTALLATION

1) Remove washer, lock nut and connect tee.

2) Apply plumbers’ putty or sealant.

3) Locate mounting hole and insert spout into deck or lavatory.

4) Screw and tighten washers, lock nut onto the shank and secure the spout

5) Insert pop-up rod into the spout.

6) Screw and tighten the connect tee to the shank.

7) Remove excessive plumbers’ putty or sealant

METAL WASHER

RUBBER WASHER

BRASS WASHER

LOCK NUT

TEFLON WASHER

CONNECT TEE

LAVATORY FAUCET INSTALLATION GUIDE

PAGE 1
TOOLS AND MATERIALS LAVATORY FAUCET INSTALLATION GUIDE Basin Wrench Adjustable wrench Teflon Tape BEFORE YOU BEGIN 1) Shut off water supply. 2) Carefully inspect waste and supply tubing for signs of damage. 3) Replace waste or supply tubing if necessary Pipe Wrench Screwdriver Flexible Water Supply Line A) SPOUT INSTALLATION 1) Remove washer, lock nut and connect tee. 2) Apply plumbers’ putty or sealant. 3) Locate mounting hole and insert spout into deck or lavatory.
PAGE 2
C) FLEXIBLE HOSE INSTALLATION 1) Install flexible hoses onto hot and cold water outlets. 2) Secure hoses with wrench. Do not over tighten. 3) Connect flexible hoses to supply tee. 4) Circle the excessive part of hoses as shown in figure below. E) SUPPLY CONNECTION 1) Install lavatory according to manufacturer’ s instructions. 2) Connect hoses (not provided) to angle stops. 3) Tighten all connections.