Owners Manual

Sink drain assembly instructions (optional)

!2 Place the end of the water supply hose in

the snap-lock clip and lock it in place. Attach

the water hose adapter.

!4 Attach the sink drain hose to the bottom

of the sink (use one tailpiece washer) and

push the sink drain hose up and over the

edge of the side panel. This will prevent the

interference between this hose and the top

rack. It also creates proper drainage from the

sink to the water tank. And/or use the cable

tie provided to hold the hose up.

!5 Slide drip tray/pan back into place and

reinstall parts removed in step 10A.

!3 Feed the air vent tube over the center divider

and attach it to the brass fitting located at the

top of the water tank.

!6 Attach cold water hose (not supplied) to the unit and test the system for leaks.

y Close the ball valve behind the cart.

y Turn on the faucet.

y Check all connections inside and outside the cart.

y If you notice any leaks, turn the water supply off. Tighten connections that are leaking and retest.

INSTALLATION

IMPORTANT!

Make sure you have the supply connection in accordance with local codes.

Tailpiece

Washer