Installation Sheet

8
7
INSTALLATION INSTRUCTIONS
FLUSH INSTALLATION
SPECIFICATIONS
The cabinet depth from the outer edge of the face frame to the inside back of the cabinet or wall should be at
least 26 3/16” inches (see figure 02B).
The Warming Drawer should be installed into a base cabinet with minimum outside dimensions of 18 1/2” high by
31” wide by 26 3/16 deep (see figures 03B & 04B).
Power supply required: 120 VAC; 15 amp GFI (Ground Fault Interrupt) circuit
A 120 Volt AC (GFI)
outlet should be
located below the
Warming Drawer
2-1/2” min. to
bottom of
countertop
2x4’s or similar
support
Position supporting boards as shown so
product can be secured into position.
26 3/16" (664mm) min. cabinet depth
30 3/16"
(766mm)
16 3/16"
(411mm)
30 3/16"
(766mm)
21 1/8"
(537mm)
2 3/4"
(70mm)
2 3/4"
(70mm)
16 3/16" (411mm)
FLUSH
A 120 Volt AC (GFI)
outlet should be
located below the
Warming Drawer
2-1/2” min. to
bottom of
countertop
2x4’s or similar
support
Position supporting boards as shown so
product can be secured into position.
26 3/16" (664mm) min. cabinet depth
30 3/16"
(766mm)
16 3/16"
(411mm)
30 3/16"
(766mm)
21 1/8"
(537mm)
2 3/4"
(70mm)
2 3/4"
(70mm)
16 3/16" (411mm)
FLUSH
Electrical
outlet
Installed
bracket
16”
23 1/4” (590mm)
26 1/8” (663mm)
1 1/8” (28mm)
24 1/8” (613mm)
11-11/16”
(297mm)
12-1/4”
(311mm)
13/16”
(20mm)
1”(25mm)
30”
14 -7/16”
(367mm)
1 -5/8”
(41mm)
Drain
Electrical
outlet
Installed
bracket
16”
23 1/4” (590mm)
26 1/8” (663mm)
1 1/8” (28mm)
24 1/8” (613mm)
11-11/16”
(297mm)
12-1/4”
(311mm)
13/16”
(20mm)
1”(25mm)
30”
14 -7/16”
(367mm)
1 -5/8”
(41mm)
Drain
Fig. 02B
Fig. 03B
Fig. 04B
CUTOUT DIMENSIONS