User manual

dCS 950 / 952 User Manual Manual for Software Version 6.2x
dCS Ltd 22
nd
May 2000
Manual part no: DOC0029526B1 Page 11 Document No: OS-MA-D0002-952.6B1
Contact dCS on + 44 1799 531 999 email to: [e-mail]
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
Remote 9 pin D type male
If the Windows™ Remote software is in use, connecting the Remote port to a
com port on a PC running the Remote Control program allows the unit to be
controlled by the PC. In addition, the unit may be software upgraded without
removing the lid, by downloading new software via the Remote port.
Connect up the Remote port using a 9-way screened cable, fitted with 9-way ‘D’-
type female connectors at each end, wired pin 1 to pin 1, pin 2 to pin 2, etc.
Suitable cables are available from dCS.
Mains Supply 3 pin IEC (CEE22)
Switched, fused and filtered IEC mains connector.
Additional Information
As well as connectors, the rear panel displays the following information about
the unit, near the mains supply connector:
Mains Voltage The actual voltage setting supplied.
Manufacturers name and address
The underside of the unit will have a label on that contains a number such as
952 4B1 6B2 2A1 3A2 12345. This is the serial number, but it also contains vital
configuration information. We will need this number (all of it) to give you support
over the phone, or to ship you software updates.