User manual

dCS 950 / 952 User Manual Manual for Software Version 6.2x
dCS Ltd 22
nd
May 2000
Manual part no: DOC0029526B1 Page 15 Document No: OS-MA-D0002-952.6B1
Contact dCS on + 44 1799 531 999 email to: [e-mail]
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
xxx The sample rate, in kS/s (32, 44.1, 48, 88.2 or 96).
b xxx Slaved to the BNC Word Clock In.
d xxx Temporary display during locking – the unit has
detected the base reference sample rate and is
attempting to lock to it.
. xxx Temporary display during locking – the unit is lining
up word clock out to word clock in.
Important error messages are given below – a full list is given in the section
“Error Codes and Messages” on page 48.
BadFs The clock source is not in pull in range, or is poorly
formatted. The unit cannot lock to it.
Err.xy An error has been detected. Please refer to
“Internal Device Error Codes” on page 48 for
more specific details on error codes.
Hot The unit is overheating, probably due to inadequate
ventilation. Please check positioning and cooling.
Ouch The “Hot” warning has been ignored and the unit is
getting so hot that damage may follow.
(blank) If the display is completely blank for any significant
period, try switching off for 10 seconds then
switching on again. If this does not solve the
problem, contact your distributor or dCS.
The display is also used for Menu options.