User manual

dCS 950 / 952 User Manual Manual for Software Version 6.2x
dCS Ltd 22
nd
May 2000
Manual part no: DOC0029526B1 Page 17 Document No: OS-MA-D0002-952.6B1
Contact dCS on + 44 1799 531 999 email to: [e-mail]
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
The Menu Sequence
To access the Function Menu, hold down the
Menu Step
button and press the
Menu Set
(Mute)
button.
(The
Menu Step
button corresponds to the selected input - LED bright or flashing.)
To step through the Menu items, press the
Menu Step
button repeatedly.
To select an item or one of its options, press the
Menu Set
(Mute)
button.
Use
Menu Up
(De-Emphasis)
and
Menu Down
(Phase)
buttons to alter
RS232
address, Tone
Level
and Tone
Frequency
.
To exit the Function Menu, either select the
End
item or wait five seconds.
Func Issue DSD Test Data 7 - Seg
Opens the
Function Menu
Displays the
fitted software
issue number
DSD mode is
available on the
dCS 954
only
Runs a display
and DSP self
test routine
Displays the
message data -
see manual
Disables the 7-
segment display
when idle.
v 6.20 Off On
Off
Tone Ref In RS232 A-Sel A-Cut Heat
Turns on and
sets a test tone
This feature is
available on the
dCS 954
only
Displays and
sets the unit's
RS232 address
Enables
automatic input
selection
Controls the
automatic
muting
Displays the
internal
temperature
Level (dB) - - - - - 0 ... 99 On On Fahrenheit
Freq (kHz) Off Off Celsius
On / Off
Up
Sys I-For Filt BNC I BNC BNC O
Turns on a full
scale system
test signal
Sets the AES
input multiwire
format
Selects an
alternative anti-
alias filter
This feature is
available on the
dCS 954
only
Sets the mode
of the BNC
button
This feature is
available on the
dCS 954
only
Off Auto Filt 1 SDIF Input SDIF
Sys - On US[1] Filt 2 RefCl
CAUTION! LOUD! US[2] * …
Filt n
Flip S - No Part Facs Phone Panel
Digitally swaps
Left and Right
outputs
Displays the
control PCB
serial number
Displays the
control PCB
part number
Displays
dCS
fax number
Displays
dCS
telephone
number
Sets Phase &
De-Emphasis to
control Volume
Off 0002-540-?-? dCS002540? Phase
On Vol
Loc End
Locks out the
front panel
controls
Exits the
Function Menu
* Implemented on
dCS 952
only.
Off
On
v6.2x software
Figure 4 – Menu Sequence