User manual

dCS 950 / 952 User Manual Manual for Software Version 6.2x
dCS Ltd 22
nd
May 2000
Manual part no: DOC0029526B1 Page 23 Document No: OS-MA-D0002-952.6B1
Contact dCS on + 44 1799 531 999 email to: [e-mail]
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
BNC -
This controls the operation of the SDIF-2 button.
Input Configures the BNC input connectors as a data
input. Press the SDIF-2 button to select it.
RefCl Configures the BNC Word Clock In connector as a
reference clock input. Press the SDIF-2 button to
sync the unit to an external SDIF-2 Word clock
while taking data from the AES or SPDIF inputs.
The SDIF-2 LED will light, in addition to the LED(s)
for the data source. Press the SDIF-2 button again
to sync to the data input instead.
BNC O -
This feature is available on the dCS 954 only – it is permanently set to SDIF.
Panel -
Sets the operation of the Phase and De-Emphasis buttons.
Phase Sets the two buttons to their standard functions.
Vol The two buttons act as a digital volume control.
Phase reduces the Volume in 0.1dB steps, while
De-Emphasis increases the Volume. The change
accelerates if a button is held down. The range is
0dB to –20dB.
Phone -
dCS telephone number scrolls across the display.
Facs -
dCS fax number scrolls across the display
Part -
The control board part number (version) scrolls along the display.
S-No -
The control board serial number scrolls along the display. You will need
something to write this on, if you call us for help.
Flip -
Normally set to Off. If you find the Left and Right outputs from your system are
reversed due to a connection error, set Flip to On to digitally swap them back.
The main display shows Flipd while this feature is turned on. Flip is not stored at
power down so you should correct the error and turn Flip Off.
Loc -
Front panel Lock, normally Off. Set to On to prevent unauthorised changes
using the front panel buttons. The menu has to be accessed in the usual way to
turn the lock off again.
End -
Exits the menu.