User manual

dCS 950 / 952 User Manual Manual for Software Version 6.2x
dCS Ltd 22
nd
May 2000
Manual part no: DOC0029526B1 Page 24 Document No: OS-MA-D0002-952.6B1
Contact dCS on + 44 1799 531 999 email to: [e-mail]
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
TYPICAL APPLICATIONS
Using a Master Clock to Sync a dCS 950 or 952
Figure 7 – Syncing to a Master Clock
do this: Set the dCS 992 Master Clock to the same sample rate as the source.
do this: Set up the dCS 950 or 952 as follows:
Set BNC in the menu to RefCl.
Select the required input (AES1 if connected as shown above).
Press the SDIF-2 button as well to sync to the Master Clock.
To use an SDIF-2 source with a Master Clock:
do this: Set the dCS 992 Master Clock to the same sample rate as the source.
do this: Set up the dCS 950 or 952 as follows:
Set BNC in the menu to Input.
Connect the source to the SDIF Ch1 & Ch2 inputs.
Connect the Master Clock to Clk In.
Press the SDIF-2 button.
AES data
from source
Balanced
outputs
Unbalanced
outputs
- or -
To pre or power amplifier
L R
L
R
AES 1 AES 2 AES 3 AES 4
AES/EBU Outputs
Wordclock Outputs
1 2 3 4 5 6
7 8 9 10 11 12
External
Sync
Remote
In
Loop
Out
Mains Fuse (2AT)
On Off
dCS 992
dCS 950 or 952
Word Clock
to source
CH2(R)
Balanced Output
dCS DAC
Cambridge, UK.
CH1(L)
Output LevelCH2(R)CH1(L)
Monitor Output
CH1(L)
AES/EBU
CH2(R)
AES 1
SDIF-2
CLK IN
CLK OUT
CH1 CH2
AES 2
SPDIF 1SPDIF 2
Remote
Serial No.
Options
SPDIF 3
Connecting To Supply
See Installation Instructions Before
MAINS FUSE (2AT) ON
50/60
Before Removing Cover
V
Disconnect Mains
Hz
OFF
PUSH PUSH