OUTDOOR GRILL BE1-30 Models USER GUIDE US CA
! DANGER IF YOU SMELL GAS • Shut off gas to the appliance. • Extinguish any open flame. • Open lid. • If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. ! WARNING • Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance. • An LP cylinder not connected for use must not be stored in the vicinity of this or any other appliance.
CONTENTS Introduction 3 Safety and warnings 4 Before you begin 9 Lighting instructions 10 Using the grill 12 Leak testing 14 Burner adjustment 15 Care and cleaning 17 Troubleshooting Warranty and service 20 21 1
INTRODUCTION Giving you the searing heat and precise control of DCS appliances, the Series 9 All Grill gives you 525 square inches of flat top grilling space with up 50,000 BTU. Designed with flexibility in mind, the All Grill can be built-in to match the full suite of professional styled DCS Series 9 products, or mounted on a freestanding cart to create the complete outdoor kitchen for your backyard.
SAFETY AND WARNINGS ! WARNING! Electric Shock Hazard Failure to follow this advice may result in electric shock or death. • This appliance is equipped with a three-prong or four-prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded power outlet. • Never remove the grounding plug or use with a 2 prong adapter.
SAFETY AND WARNINGS ! WARNING! Hot Surface Hazard Failure to follow this advice may result in fire, burns, scalds or personal injury. • Accessible parts may become hot during use. • When in use, do not touch the burner, grate, or immediate surrounding area as these areas become extremely hot. Clean the with caution. • Never let clothing or other flammable materials come in contact with or get too close to any grate, burner or hot surface until it has cooled. • Never lean over an open unit.
SAFETY AND WARNINGS ! WARNING! Explosion Hazard Failure to follow this advice may result in injury or death • If you smell gas, do not use the appliance. • Do not use water on grease fires, a violent steam explosion may result. Turn all burners off, then smother fire or flame or use dry chemical or foam-type extinguisher. • Do not heat unopened food containers such as cans – build up of pressure may cause container to burst and result in injury.
SAFETY AND WARNINGS zz zz Do not store a full LP tank in direct sunlight. After a period of storage or non-use, the appliance should be checked for gas leaks, deterioration, proper assembly, and burner obstructions before use. General Use zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz This appliance is not intended to be installed in or on recreational vehicles, trailers or boats. After lighting burners, ensure they are operating correctly.
SAFETY AND WARNINGS Gas requirements zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz 8 This appliance can be used with any brand of 20lb LP gas tank provided it is compatible with a proper retention device (not supplied). The LP gas cylinder must be: zz Designed for use with a Type 1 system only. zz Constructed and marked in accordance with the Specifications for LP gas Cylinders of the U.S. Department of Transportation (D.O.T.
BEFORE YOU BEGIN zz zz zz Ensure the installer has completed the final checklist in the installation guide. Read this guide, taking special note of the safety and warnings section. Remove all packaging and dispose of it responsibly. Recycle items that you can. Grill Features 1 Control dials 2 Dual-sided grates 2 3 Drip pan Not shown: lid Dial halos When a dial is in use, an orange halo around that dial will illuminate.
LIGHTING INSTRUCTIONS If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been turned OFF. This is normal for propane gas. 1 Remove the cover and any cooking utensils. Ensure the drip pan is in place. 2 Push in and hold the selected dial for 2 seconds before turning to SEAR. Hold for 5 seconds to light the selected burner. 3 If burner does not light in 5 seconds, turn dial back to OFF and wait 5 minutes before trying again.
LIGHTING INSTRUCTIONS Manual lighting If the burner will not light after several attempts, the burner can be manually lit. If you have attempted to light the burner with the ignition, allow 5 minutes for any accumulated gas to dissipate. 1 Remove the cover and any cooking utensils. Ensure the drip pan is in place. 2 Hold a match over the hole located on the top left for burner on the left, or the right hole for the right burner. 3 Push and turn the corresponding control dial to SEAR.
USING THE GRILL Using the grill 1 Remove the cover and any cooking utensils. Ensure the drip pan is in place. Light the grill burners following the lighting instructions and preheat. 2 Place food on the grill and cook to the desired level. You can adjust the heat setting during cooking if needed. When finished Turn control dial to OFF and shut the main gas supply. Allow the grill to cool and clean after each use.
USING THE GRILL Dual-sided grates The dual-sided grate provides cooking options for food of varying textures. One side has a W-shaped surface that creates nice sear lines for steaks, chicken, chops and routes oil and grease away from food. The other side has a radius surface area providing more support for handling of delicate food items.
LEAK TESTING A complete gas tightness check must be performed at the installation site. Periodically check the whole system for leaks, or immediately if the smell of gas is present. When using a LP gas cylinder ensure it is installed in a vertical position to provide the required vapor withdrawal. Prepare soap solution by combining one part liquid detergent and one part water. Pour into a spray bottle. Ensure all control valves are in the OFF position before turning the gas supply ON.
BURNER ADJUSTMENT Flame height adjustment Flames should be blue and stable with no yellow tips, excessive noise or lifting (Note: LP units may have some yellow tipping). If any of these conditions exist, check the air shutter and burner ports are clear. If cleaning these does not improve performance, the air shutter can be adjusted as per the instructions below. Ensure the grill is OFF and cool. 1 To access the air shutters, remove the grate, radiant and U-burner.
BURNER ADJUSTMENT Low flame adjustment The valves on the grill feature an adjustable low setting. Due to fluctuations in gas pressure, or heating value you may want to increase or decrease gas flow in the low position. If the gas type has been converted from natural to LP or vice-versa, the low flame setting must be reviewed and adjusted. 1 Push in and hold the selected dial for 2 seconds before turning to SEAR. Hold for 10 seconds to light the selected burner.
CARE AND CLEANING Regulator and hose replacement The pressure regulator and hose assembly supplied with the unit must be used. If replacements are needed, contact customer care at dcsappliances.com. Resetting the flow control Failure to follow the steps in the order shown may cause the Flow Limiting Device to activate resulting in extremely low gas flow and irregular operation. 1 All dials must be in the OFF position.
CARE AND CLEANING Removing the burners for cleaning Ensure the grill is OFF and cool. 1 Remove the grill grates, then lift out the radiant tray. remove screw 2 3 Use a screw driver to open the bracket slot at the rear of the unit Press the bracket down while pulling the burner back and up. This should remove the burner from the bracket at the rear and the opening in the control panel. Angle the burner sideways to remove.
CARE AND CLEANING Burner alignment 3⁄8”MIN REMOVE DRIP PAN TO VIEW CONNECTION Ensure the air shutters are not misaligned from their original position. Lower the rear of the burner into the cutouts on the support channel at the rear of the burner box. Ensure it is level and does not rock. Light all of the burners and check that the flame is blue, stable and even (refer to page 15 for detail). Complete any adjustments prior to cooking.
TROUBLESHOOTING If there is a problem with your grill, please check the following before contacting your local Fisher & Paykel trained and supported service technician or DCS Customer Care Centre. PROBLEM POSSIBLE CAUSES WHAT TO DO The grill won't light when the ignition is pushed There is no gas flowing to the unit. Check gas supply and connections. Ensure no air is trapped in line. There is a something blocking the air or gas flow. Check all openings for blockages.
WARRANTY AND SERVICE Before you call for service or assistance Refer to the installation instructions and your user guide and check that: zz zz zz zz zz zz Your product is correctly installed. You are familiar with its normal operation. Model number (can be found on the inside, right side panel behind the drip pan handle. Serial number (can be found on the inside, right side panel behind the drip pan handle. Code (can be found on the inside, right side panel behind the drip pan handle.
DCSAPPLIANCES.COM © Fisher & Paykel Appliances 2019. All rights reserved. The product specifications in this document apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this document correctly describes the product currently available. US CA 592073A 11.