Liberty BFG-30 Manual

Step 2

Outdoor Appliance Head Preparation

. First you will need to remove the angle brackets from the side

of the unit and replace them with cart mount brackets

(Fig. 06). Unit is shipped prepared for island installation.

2. Install the bracket tab on both sides of the appliance head

using 8 of the 10-24 x 1/2” screws. Install each bracket with 4

screws on each side of the outdoor appliance head

(Fig. 07 and 08).

Fig. 06

Fig. 07

Fig. 08

SCREWS

Step 3

Head Placement onto Cart (2 Persons Required)

1. Remove drip tray/pan (Fig. 09) and other removable components

(to lighten the load) such as grates, top burner caps and

components, and griddle flue cover, radiant tray and grill burner

for easier handling.

2. Two persons required to lift head (sink module shown). Placing

head on cart, place rear of head over the rear of the cart first

. 10).

hen allow the rear side tabs to first locate in the slots

on the t

op of the car

t sides

he other tabs will locat

e in the

middle and front slots as the head is lowered into position on the

car

t (F

. 11).

Fig. 09

. 10

. 11

INSTALLATION

CART ASSEMBLY INSTRUCTIONS

TABS