Installation Guide 48" Grill, LP Gas

TROUBLESHOOTING

Before calling for service

If the grill does not function properly, use the following checklist before contacting your dealer for

service. You may save the cost of a service call. Troubleshooting is for general purposes only. If the

problem persists and you feel you require service, contact your dealer or the nearest authorized

agency to perform service. Only authorized agencies can perform warranty service. Contact DCS at

www.dcsappliances.com

PROBLEM WHAT TO DO

Grill won’t light when the

burner knob is pushed.

y Check the gas supply is on.

y Ensure the grill is cool. Remove the grill top grates and the ceramic

radiant trays, watch the electrode tip. You should see a spark jump

from the tip of the ignition when the burner knob is pushed in.

y If there is no spark when burner knob is pushed in, check the battery

condition. Battery condition should be checked at least once a year.

y Attempt to match light the burner (see page 21, 22 & 32). Check to

see that other burners on the unit operate. Clean electrode tip of

anydebris.

Burner flame is yellow or

orange, in conjunction

with the odor of gas.

y Check the burner inlet for obstructions such as spider webs.

Checkthe air shutter for proper adjustment.

y Grill may be in a dusty area. Move to less dusty area if possible.

Low heat with knob in “HI/

SEAR” position.

y If only one of the burners appears low, clean the orifice and burner,

clearing ports of any obstruction (see page 35).

y Grill may be in a dusty area. Move to less dusty area if possible.

y Check for proper gas supply and pressure.

y Pre-heat grill for a full 15 minutes.

y If using LP gas, check for empty tank.

Rotisserie won’t light.

y Check the gas supply is on.

y Check there is a spark at the electrode.

y Check the rotisserie burner lights when attempting to light with a

butane lighter.

Rotisserie lights, but will

not hold flame once

button is released.

y Continue holding safety valve button in depressed position until

burner remains lit when released.