Installation Guide / User Guide

10
INSTALLATION
First you will need to remove the angle
brackets from the side of the unit and replace
them with cart mount brackets.
Note: unit is shipped prepared for island
installation.
Remove drip tray/pan and other removable
components such as grates, top burner
caps and components, and griddle flue
cover, radiant tray and grill burner for easier
handling.
Install the bracket tab on both sides using
eight of the 10-24 x 1/2” screws. Install each
bracket with four screws on each side of
the grill head. For a CAD1-48/48E, use the
appropriately labeled bracket for your grill
head and cart side.
Placing head on cart, place rear of head over
the rear of the cart first. Then allow the rear
side tabs to first locate in the slots on the top
of the cart sides. The other tabs will locate
in the middle and front slots as the head is
lowered into position on the cart.
1
1
2
2
Outdoor appliance head preparation
IMPORTANT!
For the CAD1-48/48E there are two sets of brackets. If you have the BGB48-BQR, use the
brackets labeled LEFT-48 BQR and RIGHT-48 BQR. If you have the BGB48-BQAR, use the
brackets labeled 48-BQAR.
Head placement onto cart
IMPORTANT!
z
Be aware of pinch points and sharp edges to avoid injury to arms and hand.
z
Two persons required to lift head.