User's Manual

dCS 954 User Manual Manual for Standard Software Version 1.5x
dCS Ltd June 2000
Manual part no: DOC136954 iss 2B1
Page 19
file 135954ma2b1.pdf available from website
Contact
dCS
on + 44 1799 531 999 email to: [e-mail]
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
The Menu Sequence
To access the Function Menu, hold down the
Menu Step
button and press the
Menu Set
button.
(The
Menu Step
button corresponds to the selected input - LED bright or flashing.)
To step through the Menu items, press the
Menu Step
button repeatedly.
To select an item or one of its options, press the
Menu Set
button.
Use
Menu Up
and
Menu Down
buttons to alter
RS232
address, Tone
Level
and Tone
Frequenc
y
.
To exit the Function Menu, either select the
End
item or wait five seconds.
Func Issue DSD Test Data 7 - Seg
Opens the
Function Menu
Displays the
fitted software
issue number
Selects DSD
mode
Runs a display
and DSP self
test routine
Displays the
message data -
see manual
Disables the 7-
segment display
when idle.
v 1.5x Off On
On Off
DSD3
DSD4
Tone Ref In RS232 A-Sel A-Cut Heat
Turns on and
sets a test tone
Sets the mode
of the AES Ref
I/O connectors
Displays and
sets the unit's
RS232 address
Enables
automatic input
selection
Controls the
automatic
muting
Displays the
internal
temperature
Level (dB) Route 0 ... 99 On On Fahrenheit
Freq (kHz) Loop Off Off Celsius
On / Off Loop.t
Up DDC
Sys I-For Filt BNC I BNC BNC O
Turns on a full
scale system
test signal
Sets the AES
input multiwire
format
Selects an
alternative anti-
alias filter
Sets the format
of the 75R In
connectors
Sets the mode
of the BNC
button
Sets the mode
of the 75R Out
connector
Off Auto Filt 1 SDIF Input SDIF (WC)
Sys - On US[1] Filt 2 AES RefCl AES
CAUTION! LOUD!
US[2] …
US[4] Filt n
Flip S - No Part Facs Phone Panel
Digitally swaps
Left and Right
outputs
Displays the
control PCB
serial number
Displays the
control PCB
part number
Displays
dCS
fax number
Displays
dCS
telephone
number
Sets Phase &
De-Emphasis to
control Volume
Off 0002-540-?-? dCS002540? Phase
On Vol
Loc End
Locks out the
front panel
controls
Exits the
Function Menu
Please note that DDC mode turns off the analogue outputs.
Off
Some features are not available in DSD mode.
On P3D mode is only available on some hardware configurations.
Standard software v1.5x
P3D software v1.36
Figure 4 – Menu Sequence