Technical data

User I ns tructions
17
CLEANING THE FILTER UNIT
 It is advisable to periodically inspect the center filter assembly C and, if necessary, to clean it. To
remove the assembly from the stainless steel filter
D, grip the tabs, turn them counterclockwise
and lift upwards.
 Push the outside filter from the underside to remove it from the micro-filter (see left illustration
below).
 Separate the two parts which make up the plastic filter assembly by gently squeezing the outside
filter at the arrow and pulling up on the center filter (see center illustration below).
 Periodically clean the stainless steel filter D.
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT
MAINTENANCE:
 The filters should be cleaned under running water using a stiff brush.
 It is essential to thoroughly clean the filters according to the above instructions. The dishwasher
cannot function if the filters are clogged.
 Carefully replace the filters in their seats, to avoid damaging the wash pump.
PROLONGED DISUSE:
 Run the soak program twice in succession.
 Unplug the power cord from the socket.
 Leave the door slightly open, in order to prevent the formation of unpleasant odors inside the
washing tank.
 Fill the rinse aid dispenser with rinse aid.
 Shut off the water supply tap.
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:
 Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the
water to run from the water supply tap for a few minutes.
 Plug the power cord back into the socket.
 Reconnect the water intake hose and open the tap again.
C
D
Micro-filter
Center filter
Outside filter
Arrow
Ta b
Outside filter