Installation Guide

13
Designed with flexibility in mind, the 30” griddle can be either built-in or mounted on a
freestanding cart. If the unit is to be placed onto a freestanding cart, an approved DCS
cart is required and can be purchased separately from your local DCS dealer.
CAD1-30 freestanding cart part number: 71432
FREESTANDING CART INSTALLATION (OPTIONAL)
2
2
3
1
1
Secure cart mounting brackets
using four of the supplied 10-24 x
1/2” screws on each side.
Place the griddle on the cart by
locating the rear side tabs of the unit
with the slots on the cart. Lower the
griddle and locate the remaining tabs.
The griddle should sit flush on the
cart.
Secure the griddle to the cart with
two Phillips-head screws at the rear
and three at the front.
Replace any components removed
in step 1 before referring to page 9
for gas connection advice.
Remove the support brackets from
the sides of the unit and replace with
the supplied cart mount brackets.
Remove the drip pan and any other
removable components from the
griddle.
Preparing the griddle
Securing griddle to cart
IMPORTANT!
z
For further guidance, refer to the installation
guide provided with your freestanding cart.
z
Wear gloves when handling the cart, some
edges may be sharp.
z
Two or more people are required to move
and assemble the cart.
z
Push or pull the cart at the corners, do not
move by the drawers or handles.
z
To prevent tipping, do not push down on top
of the drawers.
z
For optimal use, this product should be
located on a level surface with minimum flat
area of 30x48” (762 x 1219mm). Any bumps,
cracks or protrusions should be less than 1/4”.
z
Do not overload the drawers. The maximum
rating of each drawer is 35lbs.
support bracket
(remove on
both sides)
cart bracket
(secure on
both sides)
cart bracket
fixed to side
of griddle