Installation Guide

HARDWARE INCLUDED
5900 Skylab Road, Huntington Beach, CA 92647
Tel: [phone] • Fax: [phone]
Customer Care: 888.281.5698
www.dcsappliances.com
P/N 17780 Rev. B 11/04
PROFESSIONAL VENT HOOD IR PANEL KIT
INSTALLATION INSTRUCTIONS
Description Quantity
IR30
IR Bulb (175W-PAR) 1
IR Lamp Panel with IR bulb switch 1
Aluminum label 2
IR36
IR Bulb (175W-PAR) 2
IR Lamp Panel with 2 IR bulb switches 1
Aluminum label 2
IR48
IR Bulb (175W-PAR) 2
IR Lamp Panel with 2 IR bulb switches 1
Aluminum label 2
INSTALLATION INSTRUCTIONS:
1. Apply protective aluminum labels on
left hand and right hand side prior to
removing existing IR lamp panel (see
Fig. 02).
2. Remove the original panel by unscrew-
ing the two side screws (see Fig. 01)
CAUTION: Hold the panel in place while
removing the screws as the panel may
shift once the screws are removed.
3. Connect the IR lamp wiring to the lamp
connector (Fig. 03). Carefully install IR
panel using screws from step 2.
4. Remove and discard the protective
aluminum labels from the hood.
WARNING
To avoid any electrical shock, the installation of the IR lamp kit should be done by a
qualified electrician and before starting the installation of the hood.
IR lamp panel
IR bulb
Lamp connector
IR lamp wiring
MODELS: IR30, IR36, IR48
Aluminum label
Fig. 02
Fig. 01
Screw (2)
Fig. 03
ELECTRICAL SHOCK WARNING
Make sure the unit is disconnected from the power source.Serious injury or death could
result.