Service manual

SAFETY RECOMMENDATIONS
Automatic gate operators can produce high levels of force, therefore it is very important that all gate operator system
installers & designers are fully aware of potential hazards that exist with an incorrectly installed or designed system.
The internal safety capabilities of a gate operator system are not enough to reduce the risk of injury. The operator is only
one part of a properly installed system, which when combined with correctly installed safety devices will yield a complete
system that will not only provide convenience and security, but will be safer with a minimal risk of injury.
The following information along with the check list ( and the rest of the manual) is provided to make you aware of potential
areas that are of a safety concern. Disregarding any of the following may result in serious injury or death.
TWO WARNING SIGNS SECURELY INSTALLED
ON EACH SIDE OF GATE PANEL. (REQUIRED)
1 0R 2 SAFETY PHOTO BEAMS INSTALLED, ONE ACROSS EACH SIDE OF GATE OPENING/ ARC OF GATE.
1 STOP PHOTO BEAM INSTALLED ACROSS THE DANGER ZONE WHERE DRIVEARM IS LOCATED (BACK AREA).
PHOTO BEAMS INSTALLED ACCORDING TO THEIR INSTRUCTIONS & IN AREAS THAT POSE ENTRAPMENT
RISK.
CUSTOMER ADVISED THAT GATE IS FOR VEHICULAR TRAFFIC ONLY. (REQUIRED)
A SEPARATE PEDESTRIAN ENTRY AND / OR EXIT IS PROVIDED. (REQUIRED)
CONTACT EDGES INSTALLED AND FUNCTIONAL AT ALL HAZARD OR PINCH POINTS.
ARE ALL CONTROLS LOCATED FAR OUT OF REACH OF GATE, FIXED PANEL & OPERATOR. (REQUIRED)
IS THIS CLASS OPERATOR APPROVED FOR THE APPLICATION OF THE OPERATOR (CLASS 1,2,3,4) (REQ).
ARE CONTROLS INTENDED TO RESET GATE AFTER OBSTRUCTED INSTALLED IN LINE OF SIGHT.(REQ)
HARD WIRED CONTACT SENSORS LOCATED & WIRED TO AVOID ANY MECHANICAL DAMAGE.
CUSTOMER INSTRUCTED AND IS CLEAR ON PROPER USE OF GATE OPERATOR. (REQUIRED)
CUSTOMER INSTRUCTED ON PROPER USE OF ALL CONTROL DEVICES USED WITH OPERATOR. (REQUIRED)
SAFETY INSTRUCTIONS WERE REVIEWED AND LEFT WITH CUSTOMER. (REQUIRED)
DID INSTALLER OFFER A PREVENTATIVE SERVICE/MAINTENANCE CONTRACT.
A PHOTO OF COMPLETED INSTALLATION TAKEN FROM FRONT AND BACK OF GATE & DATED.
ADVISED CUSTOMER ON UNITS MANUAL OPERATION THEY MUST REMOVE ARM COVER, THEN PULL OUT PIN
DO NOT DISCONNECT THE SIREN IN ANY WAY- SWITCH S1#6 MUST STAY ON & S1#8 MUST
STAY OFF. TAMPERING WITH THE SIREN OF SWITCH SETTINGS MAY POSE THE RISK OF
SERIOUS INJURY OR DEATH.
Page A4