User guide

Developers guidelines | AT commands
119 June 2010
AT+COLP Connected line identification presentation
<m> Description
0 ”Multiple called numbers service” is not provisioned
1 ”Multiple called numbers service” is provisioned
2 Unknown (no network, and so on)
Description: This command refers to the GSM/UMTS supplementary service COLP
(Connected Line Identification Presentation) that enables a calling sub-
scriber to get the connected line identity (COL) of the called party after set-
ting up a mobile originated call. The command enables or disables the
presentation of the COL at the terminal equipment. It has no effect on the
execution of the supplementary service COLR in the network.
When enabled (and called subscriber allows), +COLP:
<number>,<type>[,<subaddr>,<satype> [,<alpha>]] intermediate result
code is returned from the phone to terminal equipment before any +CR or
V.25ter responses.
Execution
command: AT+COLP=[<n>]
Read command: AT+COLP? Displays the current <n> and <m> settings.
Test command: AT+COLP=? Shows if the command is supported.
Test command
response: +COLP: (list of supported <n>s)
Parameters:
<n>: Sets/shows the result code presentation status in the phone.
<n> Description
0 Enable result code presentation status. Default
value
1 Disable result code presentation status
<m>: Shows the subscriber COLP service status in the network.
<m> Description
0 COLP not provisioned
1 COLP provisioned
2 Unknown, for example, no network