User guide

Developers guidelines | AT commands
180 June 2010
AT+CRES Restore settings
AT+CNMI New messages indication to TE (ver. 4)
Description: Restores the message service settings from non-volatile memory to active
memory. A TA can contain several profiles of settings. The settings
specified in AT+CSCA are restored. Certain settings, for example, SIM
SMS parameters, may not be supported by the storage and can therefore
not be restored.
Execution
command: AT+CRES[=<profile>]
Test command: AT+CRES=? Shows if the command is supported.
Test command
response: +CRES: (list of supported <profile>s)
Parameter:
<profile>:
<profile> Description
0..255 Manufacturer specific profile number where
settings are to be stored. Default value: 0
Description: Selects procedure how receiving of new messages from the network is
indicated to the TE when TE is active, for example, DTR signal is ON. If TE
is inactive, for example, DTR signal is OFF, message receiving should be
done as specified in GSM 03.38 (3G TS 23.038).
Set command: AT+CNMI=[<mode>[,<mt>[,<bm>[,<ds>[,<bfr>]]]]]
Read command: AT+CNMI? Displays the current settings.
Read command
response: +CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
Test command: AT+CNMI=? Shows if the command is supported.
Test command
response: +CNMI: (list of supported <mode>s),(list of supported <mt>s),(list of
supported <bm>s),(list of supported <ds>s),(list of supported <bfr>s)
Parameters:
<mode>:
<mode> Description
2 Buffer unsolicited result code in TA when TA – TE
link is reserved, for example, in online data mode,
and flush them to the TE after reservation.
Otherwise forward them directly to the TE
<mt>:
<mt> Description
0 No SMS-DELIVER indications are routed to the TE.
Default value