User guide

Developers guidelines | AT commands
196 June 2010
AT+CGEREP Packet domain event reporting (ver. 1)
Test command: AT+CGDATA=? Shows if the command is supported.
Test command
response: +CGDATA: (list of supported <L2p>s)
Parameters:
<L2p>: Layer 2 protocol used between ME and TE.
<L2p> Description
“PPP” Point-to-Point Protocol for a PDP, such as IP
<cid>: Integer. Specifies the particular PDP context definition. See the
AT+CGDCONT command.
Description: Enables or disables sending of the unsolicited result code +CGEV from
ME to TE in the case of certain events occurring in the GPRS/Packet
Domain ME or the network. <mode> controls the processing of
unsolicited result codes specified within this command. <bfr> controls the
effect on buffered codes when <mode> 1 or 2 is entered.
Set command: AT+CGEREP=[<mode>[,<bfr>]]
Read command: AT+CGEREP? Displays the current <mode> and <bfr> settings.
Test command: AT+CGEREP=? Shows if the command is supported.
Test command
response: +CGEREP: (list of supported <mode>s),(list of supported <bfr>s)
Parameters:
<mode>:
<mode> Description
0 Buffer unsolicited result codes in the ME. No codes
are forwarded to the TE. Default value
1 Discard unsolicited result codes when MT – TE link
is reserved, for example, in online data mode,
otherwise forward them directly to the TE
<bfr>:
<bfr> Description
0 MT buffer of unsolicited result codes defined within
this command is cleared when <mode> 1 is
entered. Default value