User guide

Developers guidelines | AT commands
201 June 2010
Read command
response: +CGTFT: <cid>, <packet filter identifier>, <evaluation precedence index>,
<source address and subnet mask>, <protocol number (ipv4)/next header
(ipv6)>, <destination port range>, <source port range>, <ipsec security
parameter index (spi)>, <type of service (tos) (ipv4) and mask/traffic class
(ipv6) and mask>, <flow label (ipv6)>[<CR><LF>
+CGTFT: <cid>, <packet filter identifier>, <evaluation precedence index>,
<source address and subnet mask>, <protocol number (ipv4)/next header
(ipv6)>, <destination port range>, <source port range>, <ipsec security
parameter index (spi)>, <type of service (tos) (ipv4) and mask/traffic class
(ipv6) and mask>, <flow label (ipv6)>
[…]]
Test command: AT+CGTFT=? Shows if the command is supported.
Test command
response: +CGTFT: <PDP_type>, (list of supported <packet filter identifier>s), (list of
supported <evaluation precedence index>s), (list of supported <source
address and subnet mask>s), (list of supported <protocol number (ipv4)/
next header (ipv6)>s), (list of supported <destination port range>s), (list of
supported <source port range>s), (list of supported <ipsec security
parameter index (spi)>s), (list of supported <type of service (tos) (ipv4) and
mask/traffic class (ipv6) and mask>s), (list of supported <flow label
(ipv6)>s)[<CR><LF>
+CGTFT: <PDP_type>, (list of supported <packet filter identifier>s), (list of
supported <evaluation precedence index>s), (list of supported <source
address and subnet mask>s), (list of supported <protocol number (ipv4)/
next header (ipv6)>s), (list of supported <destination port range>s), (list of
supported <source port range>s), (list of supported <ipsec security
parameter index (spi)>s), (list of supported <type of service (tos) (ipv4) and
mask/traffic class (ipv6) and mask>s), (list of supported <flow label
(ipv6)>s)
[…]]
Parameters:
<cid>: See the AT+CGDCONT command. The <cid> may refer to a primary or a
secondary account.
<packet filter
identifier>:
<packet filter
identifier>
Description
1–8 Supported values
<source address and
subnet mask>:
<source address
and subnet mask>
Description
String Consists of dot-separated numeric (0–255)
parameters on the form
“a1.a2.a3.a4.m1.m2.m3.m4” for IPv4 and
“a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a
15.a16.m1.m2.m3.m4.m5.m6.m7.m8.m9.m10.m11.
m12.m13.m14.m15.m16” for IPv6