User guide

Developers guidelines | AT commands
208 June 2010
AT+CGEQMIN 3G quality of service profile (minimum acceptable)
Description: This command allows the TE to specify a minimum acceptable profile,
which is checked by the MT against the negotiated profile returned in the
Activate/Modify PDP Context Accept message.
The set command specifies a profile for the context identified by the (local)
context identification parameter, <cid>. The specified profile will be stored
in the MT and checked against the negotiated profile only at activation or
MS-initiated modification of the related context. Since this is the same
parameter that is used in the AT+CGDCONT and AT+CGDSCONT com-
mands, the +CGEQMIN command is effectively an extension to these
commands. The QoS profile consists of a number of parameters, each of
which may be set to a separate value.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the
MT supports several PDP types, the parameter value ranges for each PDP
type are returned on a separate line.
Set command: AT+CGEQMIN=[<cid> [,<Traffic class> [,<Maximum bitrate UL>
[,<Maximum bitrate DL> [,<Guaranteed bitrate UL> [,<Guaranteed bitrate
DL> [,<Delivery order> [,<Maximum SDU size> [,<SDU error ratio>
[,<Residual bit error ratio> [,<Delivery of erroneous SDUs> [,<Transfer
delay> [,<Traffic handling priority>]]]]]]]]]]]]]
Read command: AT+CGEQMIN? (Read the current general parameter settings)